Installation Manual – Wall Light

Total time: 10 to 20 minutes
Level: easy

Safety first
Always turn off the power at the electrical panel before starting.

METHOD 1 — Installation WITH drilling (recommended)

Step 1 — Turn off the power

Turn off the corresponding circuit breaker and check for the absence of voltage.

Step 2 — Mark the location

Place the wall bracket against the wall, check the alignment with a level, then mark the drilling points.

Step 3 — Drill and attach the bracket

Drill through the wall, insert the appropriate wall plugs, then screw the bracket securely in place.

Step 4 — Connect the wires

Connect the electrical wires:

  • Phase (L)

  • Neutral (N)

  • Earth so present (⏚)

Step 5 — Attach the wall light

Tuck the wires into the wall, position the wall light on the bracket and tighten the retaining screws.

Step 6 — Testing

Restore power and test the lighting.

METHOD 2 — Installation WITHOUT drilling (fragile wall / rental)

Only if the wall light is lightweight
Use high-strength adhesive strips (3M™ type).

Step 1 — Prepare the surface

Clean and dry the wall thoroughly (smooth surface required).

Step 2 — Apply the adhesive strips

Stick the strips to the back of the wall light bracket.

Step 3 — Attach the wall light

Press firmly against the wall for 30 seconds.

Step 4 — Connect and test

Connect the wires, restore power, and test.

Practical advice

  • For a harmonious look: install the wall lights in pairs , at the same height.

  • Recommended height: 150–170 cm from the ground

  • Always use LED bulbs